Off-Topic > The Lounge
Which way do you prefer your engineering tools?
Lanliss:
Submit, submit to the might of spanner-mallet, you mallet-spanner peons. You cannot stand against us, you cannot stop us, for we repair better than you. You will submit, or you will fall.
MightyKeb:
You see Lanliss, a very wise man, who also was a mallet-spanner advocator by the way, which isnt very hard to figure for all intellectual men prefer mallet spanner, has said: "The Hull goeth before a fall.", ultimately thy ways are countered by something as simple as a gat mortar! Mallet-spanner also comes with the added benefit of not smacking that 3 second cooldown in with the spanner by accident after the rebuild. So in both short and long term, spanner-mallet falls short.
David Dire:
--- Quote from: MightyKeb on April 03, 2015, 02:46:38 pm ---You see Lanliss, a very wise man, who also was a mallet-spanner advocator by the way, which isnt very hard to figure for all intellectual men prefer mallet spanner, has said: "The Hull goeth before a fall.", ultimately thy ways are countered by something as simple as a gat mortar! Mallet-spanner also comes with the added benefit of not smacking that 3 second cooldown in with the spanner by accident after the rebuild. So in both short and long term, spanner-mallet falls short.
--- End quote ---
Thou speaketh truth.
BlackenedPies:
I think the 'other' votes are skewing the results. The question is if you put spanner or mallet in front of the other.
That way mallet chem spanner would be a vote for mallet, or my vote of chem mallet spanner.
Lanliss:
They are not skewing the results. The question is "do you prefer mallet-spanner-insert item here, spanner-mallet-insert item here, or something else, that is neither mallet-spanner or spanner-mallet?". It is not just a question of what you prefer in first slot, but also what you want in second.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version