Main > Gameplay
1.3 General Speculation
RearAdmiralZill:
Now show us buffed greased.
Echoez:
It all depents, buff will last for a single clip, unless you clear up the engagement, you won't have enough time to both shoot and buff the gatling again, which will leave you with crippled damage unless everything goes according to plan.
At least that's how I see it. Remember pin point accuracy isn't always a good thing, the slightest turn will be throwing even the best gunner's aim off and with the lower clip capacity, every shot you miss counts a lot more than before.
N-Sunderland:
Buffed greased would suffer from the same issues as normal greased, and it'd be awkward to pull off. You'd need an engineer to buff the gat, then run over to their own gun. It might work on anti-Galleon Pyra builds, but that's about it.
And Echo, your argument would be perfectly valid if it wasn't wrong :P The gun buff lasts 20 seconds. 7.2 second clip, plus a five-second reload. The buff lasts two clips. In addition, the two reloads from those clips add up to 10 seconds. It takes 6 seconds to buff a gun.
RearAdmiralZill:
Are you still assuming a 3 engineer build? If so, this is all going to get stupidly confusing again.
You silly people.
N-Sunderland:
I'm assuming a three-engineer build if you choose a buff hammer over greased.
I'm assuming a two engi, one gunner build if greased is being used.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version